Abstract
Abstract Austenitic high-Mn steels are regarded as a promising candidate for high-strength cold-rolled steels because their combination of strength and ductility improves greatly by combined effects of twinning-induced plasticity (TWIP) and transformation-induced plasticity (TRIP). Although it is well known that Al plays key roles in tensile properties of austenitic TWIP steels, its effects in austenitic TRIP or TRIP/TWIP steel are still unclear yet. In this study, three austenitic steels (composition; 0.4C–15Mn–1Si-(0,0.5,1)Al-0.3Mo-0.5V (wt.%)) were fabricated, and the effect of Al alloying on microstructures and tensile properties were investigated in relation to the deformation behavior with TRIP and TWIP mechanisms. A partial recrystallization was conducted for enhancing the yield strength, which was characterized with electron backscatter diffraction (EBSD) grain orientation spread maps. The present steels showed 1 GPa of yield strength achieved by partial recrystallization with the precipitation of (V + Mo) complex carbides. Particularly in the non-Al-alloyed steel, the e-martensite formed in the early deformation stage, and the martensitic transformation continued until the failure, thereby resulting in the highest tensile strength (1.5 GPa) along with the highest strain hardening.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
