Abstract
Purpose – This paper aims to investigate the transformations during aging at 200°C for different periods on microstructure and mechanical properties of high-temperature Zn-4Al-3Mg solders. Design/methodology/approach – The solder was melted in a resistance furnace, and different cooling rates were obtained by changing the cooling medium. Subsequently, all the specimens were aged at 200°C for 20 h and 50 h. A scanning electron microscope equipped with an energy dispersive X-ray detector and X-ray diffraction were used for the observation of microstructures and the determination of phase composition. Tensile tests and Rockwell hardness tests were also performed. Findings – After aging, Zn atoms precipitated from the supersaturated α-Al and the (α-Al + η-Zn)eutectoid phase with the original fine lamellar structure coarsened and spheroidized to minimize the system energy. Among these solders, the furnace-cooled alloys exhibited the highest thermal stability, largely retaining their original morphology after aging, whereas the collapse and spheroidization of the η-Zn phase and the coarsening of the η-Zn dendrites took place in the air-cooled and water-cooled samples, respectively. Furthermore, a decrease in tensile strength during aging was attributed to the thermal softening effect. The variation of macro-hardness was mainly associated with the microstructural alterations in terms of quantity, morphology and distribution of soft η-Zn phase and hard intermetallic compounds induced by the aging treatment. Originality/value – The structural stability of eutectic Zn-4Al-3Mg solders solidified at different cooling rates and the effect of aging on mechanical properties were investigated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have