Effects of a single spanwise surface wire on a free-ended circular cylinder undergoing vortex-induced vibration in the lower synchronization range

Abstract

This experimental study investigated the control induced by a spanwise surface wire on a rigid circular cylinder undergoing vortex-induced vibration (VIV) under the conditions of low mass damping in the lower synchronization branch. Being motivated by the idea of VIV-based energy harvesting from ocean and river flows, this elastically mounted cylinder was immersed in a water channel, leaving a free end at its bottom spanwise end, while the free water surface bounded its top. The cylinder was constrained to vibrate in the cross-stream direction. The wire diameter was 6.25 % of the cylinder diameter. Experimental research was conducted by attaching this large-scale wire along the span of the cylinder at various angular positions ranging from 0° to 180° (with respect to the most upstream point of the cylinder) at a fixed Reynolds number of 104(based on the cylinder diameter). Simultaneous to measuring the trajectory of the cylinder motion via a laser distance sensor, the instantaneous velocity field in the near wake of the cylinder was obtained using particle image velocimetry. Several VIV response categories were identified depending on the angular position of the wire, which led to the classification of distinct angular ranges for the wire application. Associated with the structural vibrations in these categories, different vortex-formation modes induced by the wire were revealed. For specific wire positions, decreases of up to 98 % and increases of up to 102 % were identified in the oscillation amplitude of the cylinder compared with the amplitude of the clean cylinder under similar conditions.