Effects of a Forced Solution Flow on the Step Advancement on {110} Faces of Tetragonal Lysozyme Crystals: Direct Visualization of Individual Steps under a Forced Solution Flow

Abstract

To grow protein crystals of better quality, there still exists an open question whether a solution flow should be suppressed or intentionally introduced. To obtain a comprehensive understanding of the effects of a solution flow, we directly measured the velocities of individual elementary steps (on {110} faces of tetragonal lysozyme crystals) under a forced solution flow, for the first time, by laser confocal microscopy combined with differential interference contrast microscopy. When we used crystals grown by a two-dimensional (2D) nucleation growth mechanism in a solution of commercial lysozyme (98.5% purity, from Seikagaku Co.), while increasing the solution flow rate, the step velocity decreased monotonically. We confirmed that this decrease in the step velocity with flow rate was due to the enhancement of the mass transfer of impurity (mainly covalently bonded dimer), by the observation using a lysozyme further purified (dimer was removed). In contrast, when we used crystals grown by a spiral growth mechanism in a commercial lysozyme solution, with increasing the flow rate, the step velocity increased and had the maximum at the flow rate of 10 μm/s, and then decreased monotonically. Also, the step velocity was 2–4 times higher than in the case of the 2D nucleation growth. These results demonstrate that the growth of spiral steps is less affected by impurities because the density of spiral steps is much higher than that of 2D island ones.