Abstract
The effects of titanium modification, which was added along with the pouring liquid in ladles, on the shrinkage porosity and cavity of cast steel ZG35 smelted in intermediate frequency induction furnace were studied. Proper content of titanium could effectively increase the volume of concentrated shrinkage cavity, and restrain the forming of shrinkage porosity. The concentrated shrinkage cavity was analyzed quantitatively by stuffing wet gluten and draining water method. The maximal cavity arrived at 0.15wt.% titanium modification. By scanning electron microscope (SEM) and energy disperse spectroscope (EDS) analysis, it was found that TiC, acting as heterogeneous nuclei, could refine the structure grains, diminish the strong dendrites, and increase the fluidity and feeding capacity of steel liquid. However, overdoes titanium modification easily caused mass nitrides or oxides, which kept solid phases with high meting point in metal liquid to increase its viscosity and decrease the fluidity. On the other hand, these solid state titanium compounds enlarged the composition supercooling, so the metal liquid changed from sequential solidification to simultaneous solidification, resulting in inadequate metal liquid feeding, less oncentrated shrinkage cavity and serious shrinkage porosity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.