Effective thermal conductivity of sintered porous media: Model and experimental validation

Abstract

A model to estimate the effective thermal conductivity of sintered porous media for heat pipes is proposed in this paper. An elementary cell of a porous media is physically modeled as two metallic hemispheres in contact with a fluid film around them. The electrical circuit analogy is employed to determine the heat leaving the top and reaching the bottom of the cell. The thermal circuit consists of two parallel resistance paths, one for the solid spheres in contact and the other for the heat transfer in the fluid. A literature model is employed to calculate the thermal resistance within the hemispherical particles. Also, literature models are used for the determination of the geometry of the neck produced between particles during the sintering process. The neck dimensions are used to estimate the neck thermal resistance, which is in series with the hemisphere resistances. Effective thermal conductivity experimental data were obtained for porous materials produced with atomized copper powder, with particle diameters ranging from 20 to 50μm. The comparison between present model and data is good. Statistics of the particle size distribution is employed to determine average particle dimensions. The porosity and permeability of the material tested was characterized in the laboratory. The samples were tested in three conditions: vacuum and saturated with distilled water or methanol. Literature models for the effective thermal conductivity for bed packed (not sintered) porous media were also compared with the present model and data results.