Effective multi-objective inverse lithography technology at full-field and full-chip levels with a hybrid dynamic priority algorithm.

Abstract

Inverse lithography technology (ILT), such as source mask optimization (SMO), is used to improve lithography performance. Usually, a single objective cost function is selected in ILT, and an optimal structure for one field point is achieved. The optimal structure is not the case for other images at full field points where the aberrations of the lithography system are different, even in high-quality lithography tools. The optimal structure that must match the high-performance images at the full field is urgently required for extreme ultraviolet lithography (EUVL). In contrast, multi-objective optimization algorithms (MOAs) limit the application of multi-objective ILT. Assigning target priority is incomplete in current MOAs, which results in the over-optimization of some targets and under-optimization of others. In this study, multi-objective ILT and a hybrid dynamic priority (HDP) algorithm were investigated and developed. High-performance images with high fidelity and high uniformity were obtained at multi-field and multi-clip areas across the die. A hybrid criterion was developed for the completion and reasonable prioritization of each target to ensure sufficient improvement. Compared to the current MOAs, the uniformity of images at full-field points was improved by up to 31.1% by the HDP algorithm in the case of multi-field wavefront error-aware SMO. The multi-clip source optimization (SO) problem showed the universality of the HDP algorithm to deal with different ILT problems. It acquired higher imaging uniformity than existing MOAs, which indicated that the HDP is more qualified for multi-objective ILT optimization than existing MOAs.