Effective Leaching of Argillaceous and Dolomitic Carbonate Rocks for Strontium Isotope Stratigraphy

Abstract

Various methods have been developed to extract a primary seawater Sr isotope signal from carbonate rocks for strontium isotope stratigraphy. However, there is little consensus around the best method due to variable sample purity and mineralogy. For this study, we applied sequential leaching to a range of rock samples in order to explore strontium isotope leaching systematics of less favoured argillaceous and dolomitic limestone samples. Following an ammonium acetate (NH4Ac) prewash that removed ~ 10% of the carbonate fraction, a subsequent dilute acetic acid leach (10–30% aliquot) was shown to extract the lowest, demonstrably least altered seawater 87Sr/86Sr isotope ratios, along with in most cases seawater‐like rare earth element (REE) plus yttrium (Y) patterns with the highest Y/Ho ratios (mostly > 36). Subsequent dissolution steps exhibited significantly elevated 87Sr/86Sr isotope ratios, Rb/Sr, Al/Ca and Mg/Ca ratios, indicating greater contributions from aluminosilicates and dolomite in the leachates. The new dissolution method by comparison significantly increases the likelihood of obtaining primary seawater 87Sr/86Sr isotope ratios from argillaceous and dolomitic limestones where the other established procedures failed. Broad application of this approach could improve the temporal resolution of the seawater Sr isotope curve, especially where high purity limestone samples are scarce.