Effective fabrication method of 3D ceramic photonic crystals with diamond structure

Abstract

PurposeThe purpose of this paper is to present a novel and effective fabricating method of 3D ceramic photonic crystals with diamond structure.Design/methodology/approachThe reverse diamond‐structure resin molds are fabricated by stereolithography (SL), then ceramic slurry is prepared and injected into the molds under vacuum condition. Subsequently, ceramic photonic crystals are obtained after vacuum freeze‐drying and sintering.FindingsThe combination of SL, gel‐casting and freeze‐drying could be used to fabricate the 3D ceramic photonic crystals with diamond structure which have intact structure and minimal shrinkage. The samples have been tested and the experimental results indicate that their band gap is in the range of 10.14‐12.20 GHz, consistent with the simulation results.Research limitations/implicationsThe influence of fabrication process on the photonic band gap needs further study.Originality/valueThis paper presents a novel fabricating method of 3D diamond‐structure ceramic photonic crystals based on SL, gel‐casting and freeze‐drying. The method fabricates complex ceramic photonic crystals with high accuracy and helps further research in this field.