Effect on the performance of drilling fluids at downhole rock surfaces at low temperatures

Abstract

To maintain gas hydrate stability, low-temperature drilling fluids and high drilling speeds should be used while drilling in gas hydrate-bearing sediments. The effect of the drilling fluid on downhole rock surfaces at low temperatures is very important to increase the drilling rate. This paper analyzed the action mechanism of the drilling fluid on downhole rock surfaces and established a corresponding evaluation method. The softening effect of six simulated drilling fluids with 0.1 wt.% of four common surfactants and two common organic salts on the downhole rock surface strength was evaluated experimentally using the established method at low temperature. The experimental results showed that the surfactants and organic salts used in the drilling fluids aided in the reduction of the strength of the downhole rock surface, and the established evaluation method was able to quantitatively reveal the difference in the softening effect of the different drilling fluids through comparison with water. In particular, the most common surfactant that is used in drilling fluids, sodium dodecyl sulfate (SDS), had a very good softening effect while drilling under low-temperature conditions, which can be widely applied during drilling in low-temperature formations, such as natural gas hydrate-bearing sediments, the deep seafloor and permafrost.