Abstract

Laser cladding technology is an effective surface modification technique. In order to prepare coating with excellent properties on the surface of the cold heading die punch, stellite-6 cladding coating with different proportions of Y2O3 was prepared on the surface of W6Mo5Cr4V2 high-speed steel using laser cladding technology in this paper. The effects of different Y2O3 contents on the macroscopic morphology, microstructure, phase analysis, microhardness, and tribological properties of the stellite-6 coatings were investigated. It was determined that the optimal Y2O3 content for the stellite-6 powder was 2%. The results showed that the coating with 2%Y2O3 had the least number of pores and cracks and exhibited good surface flatness when joined. The microstructure became finer and denser, composed mainly of branch, cellular, equiaxed, and columnar grains. The coating consisted mainly of γ-Co, Fe-Cr, and Co3Fe7 strengthening phases, indicating good metallurgical bonding between the coating and the substrate. The average microhardness reached 539 HV when 2%Y2O3 was added, a 15.2% increase compared with the unmodified multilayer coating. The friction coefficient of the clad layer was 0.356, a 21.8% improvement over the unmodified stellite-6 coating. The average worn area of the cross-section was 3398.35 μm2, a reduction of approximately 27.8% compared with the unmodified stellite-6 clad layer. The wear surface primarily exhibited abrasive wear, with fewer cavities and a smoother surface.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call