Effect of wood surface finish on wood species classification using spectral reflectance

Abstract

Wood species can be classified by spectral reflectance. It is unclear whether finish coated on the wood surface affects the accuracy of wood species classification. This paper focused on this issue, using the spectral reflectance of 8 different kinds of finish for wood species classification. The spectral reflectance of wood surface coated with finish was modified by the transfer model in order to reduce the effect of finish on classification accuracy. The experimental results show that it is not feasible to use the spectral reflectance of wood samples coated with finish directly to classify wood species; the best classification accuracy using the eight finishes was 30%. After correcting the spectrum of wood samples coated with finishes with the direct standardization (DS) transfer model, the classification accuracy of the near-infrared (NIR) spectrum was close to that of the original spectrum without finish. However, the visible/near-infrared (VIS/NIR) spectrum did not achieve a good classification effect after correction with the DS transfer model.