Abstract
Inconel 706 superalloy has established itself in the field of gas turbine industry because of its easy fabricability combined with high mechanical strength. Due to its high stress rupture and tensile yield strength, conventional machining of this superalloy exhibits poor surface and low dimensional accuracy of the machined components. It is well known that most of the gas turbine components include complex shaped profile with high precision and hence, wire electrical discharge machining (WEDM) of Inconel 706 has been performed to achieve the feasibility in manufacturing of complex shaped components for gas turbine application. In the current investigation, the effect of wire diameter on WEDM performance characteristics such as cutting speed, surface roughness, surface topography, recast layer formation, microhardness, microstructural and metallurgical changes have been evaluated. It was investigated that smaller diameter wire is advantageous over the larger diameter wire since it improves productivity as well as surface quality of the machined components under the same settings of control parameters. In addition, smaller diameter wire has shown comparatively lower recast layer thickness, minimum hardness alteration and shorter manufacturing time. The XRD result has confirmed the presence of residual stress within WED machined component.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
