Effect of wellbore design on the production behaviour of methane hydrate-bearing sediments induced by depressurization

Abstract

Methane hydrates have been considered as the future clean energy resource. To recover energy from hydrate-bearing sediments safely and effectively requires a fundamental understanding of the dynamic behaviour of hydrates in sandy media. Past field production tests have proved the technical feasibility of gas production from hydrate reservoirs. However, technical challenges (e.g. sand production and excessive water production) remain in realizing long-term economic-viable production. In this study, we investigate the effect of various wellbore designs (specifically the shape and the location of perforations) on the fluid production behaviour in aqueous-rich hydrate-bearing sediments. Slotted-liner design was first-time incorporated in depressurization under different bottom-hole pressures (2.5 MPa, 3.0 MPa and 4.0 MPa). Continuous gas production and step-wise water production during the early stage of depressurization were observed at all pressures because of the change of fluid flow path from reservoir to wellbore. Compared with traditional borehole design, slotted-liner design showed advantage in controlling water production under low BHP (2.5 MPa). Using wellbores with different perforation locations, it was observed that perforation location does not pose a significant impact on the behaviour of gas production; whereas, middle perforation away from the aqueous-rich and hydrate-rich region yielded the least water production. The experimental results from this study demonstrated the possibility of employing slotted-liner well and varying the perforation location in reducing water production from methane hydrate-bearing sediments. Our findings can pave way for the testing of novel wellbore designs to further enhance gas recovery and reduce water production from hydrate reservoirs.