Effect of water and rock composition on re-strengthening of cohesive faults during the deceleration phase of seismic slip pulses

Abstract

The elastic strain energy release rate and seismic waves emitted during earthquakes are controlled by the on-fault temporal evolution of the shear stress during rupture propagation. High velocity friction experiments highlighted that shear stress on the fault surface evolves rapidly during seismic slip pulses. This temporal evolution of shear stress is controlled by both fault weakening at seismic slip initiation and re-strengthening rate towards the end of slip. While numerous studies focused on fault weakening, less attention was given to co-seismic re-strengthening processes. Here we performed 53 friction experiments (normal stress ≤30 MPa, slip-rate ≤6.5 ms−1) imposing constant slip acceleration and deceleration (7.8 ms−2), on cohesive Carrara marble (99% calcite) and micro-gabbro (silicate-built rock) under dry, vacuum and water pressurized conditions. Microstructural observations showed that micro-gabbro accommodated seismic slip by bulk melting of the sliding surfaces, whereas Carrara marble by coupled decarbonation and grain-size dependent crystal plastic processes. Under room humidity conditions and low imposed power density (i.e., product of normal stress per slip rate), re-strengthening rate during the deceleration stage was up to ∼ 17 times faster in marble than in micrograbbro. In the latter, the re-strengthening rate increased slightly with the power density. The presence of water enhanced further this trend. On the contrary, in marbles the re-strengthening rate decreased drastically with power density and in the presence of water. Our experimental observations highlighted the first order importance of the mineralogy and rheology of the slip zone materials and, to a second order, of the presence of water in controlling co-seismic re-strengthening of faults during seismic slip deceleration.