Abstract
Abstract This study investigated the effect of warm-working rate on the shape memory properties of Ti–49.7 at.%Ni alloy. The ingot was prepared by using an arc melting method and then warm-rolled at 673 K to reduce the thickness by 77%, 85%, and 89%. For comparison, an ingot was cold-rolled at room temperature to reduce the thickness up to 30%. The warm-worked specimens were annealed at 623–723 K for 3.6 ks, and the cold-worked specimens were annealed at 673 K for 3.6 ks. The transformation behavior was analyzed by means of differential scanning calorimeter (DSC) and tensile tests. The critical stress for slip increases with increasing warm-working rate and decreasing annealing temperature. The martensitic transformation temperature ( T R→M ) and the reverse transformation temperature ( T M→B2 ) increase with decreasing warm-working rate and increasing annealing temperature. The critical stress for slip in the warm-worked specimens is higher than that of the specimens annealed at 673 K after cold-working. Therefore, warm-working at 673 K improves the shape memory characteristics of Ti-rich Ti–Ni alloys. This suggests that Ti-rich Ti–Ni alloys are good candidate materials for actuators.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
