Abstract
Utilization of one-dimensional system analysis code such as TRACE, RELAP5, TRAC-BF1 to evaluate gas-liquid two-phase flow behaviors in nuclear power plants is crucial for the plant-level safety assessment. In the two-fluid model, interfacial momentum transfer between two phases is expressed under interfacial drag term in the momentum equation. For the rigorous and accurate expression of interfacial drag term and drift flux parameter, covariance due to the area averaging of void fraction distribution must be considered. In the present paper, an effect of the covariance on void fraction prediction in pipe flow was numerically assessed by implementing Hibiki and Ozaki's model into the interfacial drag term in the one-dimensional two-fluid model. For the low flow rate with high void fraction conditions, it was found that the inclusion of covariance model slightly underestimated void fraction value than that calculated by the drift-flux model. This underestimation comes from the momentum source term in the two-fluid model, which was derived under the assumption of uniform void fraction distribution. Therefore, in this paper, momentum source term was rederived with consideration of void fraction covariance and a complete set of momentum equation and constitutive formulations for the one-dimensional two-fluid model is presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have