Effect of Variation in the Mass Ratio on Vortex-Induced Vibration of a Circular Cylinder in Crossflow Direction at Reynold Number = 104: A Numerical Study Using RANS Model

Abstract

This study reports on the numerical analysis of the impact of mass ratio on the Vortex-Induced Vibration (VIV) phenomenon of an elastically rigid cylinder, oscillating freely in a crossflow direction. Reynolds-averaged Navier–Stokes (RANS) equations with (k-ω SST) model were used to analyze the flow behavior, amplitude ratio and vortex shedding patterns. The study was performed at constant Reynold number (Re) = 104 with reduced velocity (Ur) ranging from 2 to 14 and mass ratio (m*) of 2.4 and 11. The mass ratio was defined as the ratio between mass of the vibrating cylinder and mass of the fluid displaced. It was found that increasing the mass ratio from 2.4 to 11 resulted in decrease in amplitude response by 80%, 71% and 31% at initial branch, upper to lower transition region and lower branch, respectively. However, the amplitude in the upper branch decreased only 8% at high mass ratio. The peak amplitude observed in the present study was lower than previous experimental and DES results. However, the RANS k-ω SST well captured the vortex shedding modes of 2S, 2P, P + S, and 2T. In 2S mode, two single pairs of vortices were formed, whereas in 2P mode two pairs were generated in single oscillation. Similarly, P + S meant one pair and one individual vortex; whereas 2T mode meant two triplets of vortices generated in one oscillation. The study concluded that increase in mass ratio results in shortening of the lock-in region and decrease in amplitude response.