Abstract
In the cold metal transfer plus pulse (CMT + P) welding process of Ti-6Al-4V, a tungsten needle with ultrasonic vibration was inserted into the front side of weld pool to stir the molten pool, thereby refining the grains and improving the tensile properties of weld joint. The experimental results showed that under the experimental conditions, the ultrasonic vibration of molten pool can effectively inhibit the columnar crystal growth in the weld zone and improve the tensile properties of weld joint. When the tungsten needle was placed closer to the rear of molten pool, the effect of the ultrasonic vibration of molten pool was more significant. The ultrasonic vibration of molten pool did not change the phase composition of weld zone, but it affected its grain orientation and relative content. All tensile specimens were fractured at the weld zone, and the fracture mode was ductile / brittle mixed fracture.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.