Abstract
In this study, pure nickel and Ni-SiC composite coatings were prepared by the conventional electrodeposition technique from nickel sulfamate electrolytic bath containing dispersed SiC particles. The samples obtained after the electrodeposition were subjected to the ultrasonic nanocrystal surface modification (UNSM) technique to improve the surface- and interface-related properties of the coatings. The surface morphology, elemental composition, surface roughness, microstructure, and crystallinity were observed and analyzed by using scanning electron microscope, energy-dispersive x-ray spectroscopy, roughness tester, and x-ray diffraction techniques, respectively. Electrochemical corrosion behavior of the obtained samples was evaluated in 3.5 wt.% NaCl solution by using three electrodes configuration. XRD result revealed the enhanced crystallinity of the UNSM-treated samples. A significant improvement in surface morphology, Vickers microhardness, wear and coefficient of friction, and anti-corrosion property was observed in the UNSM-treated nickel and Ni-SiC coatings compared to the UNSM-untreated samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.