Abstract
Abstract In this study, the tribological properties of 7075 aluminum alloy produced by ultrasonic melt treatment (UST) are investigated. Tribological properties of untreated and ultrasonically treated samples under dry and lubricated sliding conditions were analyzed experimentally by the block on ring test method. Worn surfaces of untreated and ultrasonically treated samples were scanned by 3D optical profilometer and analyzed to search out wear characteristics in the material. Furthermore, microstructural examinations were conducted to investigate the beneficial effects of UST on the microstructural properties of the alloy using optical and scanning electron microscopy. According to the results obtained, UST refines the α-Al phase of the alloy and disperses precipitates to grain boundaries more uniformly. Also, hardness and density of the alloy increased through the effect of UST. Due to these favorable effects, the wear resistance of the alloy increased and the worn surfaces of the ultrasonically treated samples exhibited lower surface roughness according to 3D surface roughness measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.