Abstract
The effect of tool angles on the shapes of chips generated by parallel-to-grain and end-grain milling was explored for China fir and maple under fixed spindle and feed speeds and cutting depth. The milling path was up-milling by straight router-bits with a diameter of 12 mm. The chip shapes could be distinguished as five types: spiral, splinter, flow, thin, and granules or powder. The flow and thin chips were generated most often (on a weight percentage basis) for all tool angles investigated for parallel-to-grain and end-grain milling of China fir and maple. More granule chips were produced with parallel-to-grain milling than with end-grain milling for both woods. The measured chip thickness (t′) was thicker than the calculated thickness (t max). Thicker and longer maple chips were produced by end-grain milling than by parallel-to-grain milling. The tool geometries of 40°/15° (sharpness of the angle–rake angle), 50°/15°, and 60°/15° for China fir and 40°/25°, 50°/5°, and 60°/5° for maple produced relatively more flow chips with parallel-to-grain milling. Furthermore, the tool geometries of 40°/5°, 50°/15° and 60°/25° produced more flow chips (weight percentage) by end-grain milling of China fir and maple.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
