Abstract

In this work, titanium nitride (TiN) nanoparticles (∼20nm) were introduced during cryomilling of commercially pure titanium (CP Ti). Consolidation of cryomilled powders was performed using spark plasma sintering (SPS). Samples were analyzed and tested alongside cryomilled, SPS CP Ti not containing TiN nanoparticles. After cryomilling powders containing TiN nanoparticles and powders not containing TiN had a minimum grain size of ∼20nm. Microstructure analysis after thermal processing of both samples revealed that grain size retention occurred due to the presence of TiN nanoparticles in CP Ti microstructure. In consolidated samples containing 5vol% TiN nanoparticles, the minimum average grain size was retained to ∼250nm, while in samples containing 0vol% TiN nanoparticles, the minimum average grain size obtained was ∼750nm. Microhardness testing showed an increased hardness of samples containing TiN nanoparticles due to the retention of smaller grains and the presence of TiN nanoparticles.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.