Effect of Ti3SiC2 mass fraction on microstructure and tribological performance of laser cladded NiCr coating at high temperature

Abstract

PurposeThis paper aims to investigate the effect of Ti3SiC2 on the high-temperature tribological behaviors of NiCr coating, which was beneficial to improve the friction-wear performance of hot work mold.Design/methodology/approachNiCr-Ti3SiC2 coatings were prepared on H13 steel substrate by laser cladding. The microstructure, phases and hardness of obtained coatings were analyzed using a super-depth of field microscope, X-ray diffraction and microhardness tester, respectively, and the tribological performance of obtained coatings at 500°C was investigated using a high-temperature tester.FindingsThe results show the NiCr-Ti3SiC2 coatings are comprised of γ-Ni solid, solution, TixNiy, TiC and Ti3SiC2 phases, and the coating hardness is increased with the increase of Ti3SiC2 mass fraction, which is contributed to the fine-grain and dispersion strengthening effect by the addition of Ti3SiC2. The NiCr-Ti3SiC2 coatings present excellent friction reduction and wear resistance by the synergetic action of Ti3SiC2 lubricant and hard phase, and the wear mechanism is predominated by abrasive wear and oxidation wear.Originality/valueTi3SiC2 phase was used to reinforce the tribological performance of H13 steel at high temperature, and the roles of friction reduction and wear resistance were discussed.Peer reviewThe peer review history for this article is available at: https://publons.com/publon/10.1108/ILT-01-2023-0004/