Abstract
This paper deals with the determination of the surface quality of both thermally treated and thermally untreated wood after the plane milling process. The milled surface quality was evaluated on the basis of the arithmetical mean deviation of the assessed profile, Ra. Surface quality measurements were carried out for various milling process parameters, such as tool clearance angles of 15o, 20o, and 25o, cutting speeds of 20, 30, and 40 m/s, and feed speeds of 4, 8, and 11 m/min. A splinter with a uniform thickness of 1 mm was removed from the wood through milling. Based on the results, it can be stated that thermal treatment of wood has no statistically significant impact on roughness. The most significant impact of the monitored factors were associated with feed speed, clearance angle, and cutting speed. The lowest average roughness values were found at 20o clearance angles, a feed speed of 4 m/min, and a cutting speed of 40 m/s. Increases in cutting speed led to a decrease in average roughness, while an increase in feed speed had the opposite effect.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
