Abstract
The ultra-sharp V-notch with tip radius smaller than 0.5 μm was cut by femtosecond laser on the fine-grained alumina ceramic bars to measure the fracture toughness by single-edge V-notched beam (SEVNB) method. In order to relieve the effect of thermal stresses induced by laser on fracture toughness testing, the samples with V-notch were annealed before measurement. The morphologies of the notch tip were analyzed by SEM and micro-Raman spectra. Results reveal that the fracture toughness value of this fine-grained alumina with thermal stresses on the V-notch is equal to that after annealing, and the effect of thermal stresses induced by laser on the fracture toughness can be ignored.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
