Abstract
The effect of thermal cycling on the transformation behavior of a Ti-24Nb-1Mo alloy was investigated by means of electrical resistivity measurement, transmission electron microscopy (TEM), X-ray diffraction (XRD), tensile test and Vickers hardness tests. Electrical resistivity changes were not observed in all alloys. It indicates that thermally induced martensitic transformation does not take place in the alloys. After thermal cycling between 298 K and 77 K, clear X-ray diffraction peaks corresponding to ωath phase, which did not exist before thermal cycling, were observed. Volume fraction of ωath phase increased as increasing the number of thermal cycling. ωath phase formed during thermal cycling increased hardness of the alloy. Although thermally induced martensitic transformation did not occur in the alloys, superelastic deformation behavior was observed in the alloys. The superelastic recovery ratio decreased from 81% to 41% by increasing the number of thermal cycling, which came from the increase in the volume fraction of ωath phase.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.