Effect of the Spray Parameters on the Particle Behavior and the Coating Properties During ID Warm Spraying of Fine WC-12Co Powders (-10 + 2 μm)

Abstract

Abstract Internal diameter (ID) coating by means of thermal spraying for the wear and corrosion protection of components is currently experiencing growing interest in science and industry. While high-kinetic spray processes (such as HVOF, HVAF or warm spraying) in combination with cermet materials (e.g. WC-Co or Cr3C2-NiCr) are well established for this purpose in traditional coating of external OD (outer diameter) surfaces, they have hardly been used in the ID (internal diameter) area so far. Even though a few special ID spray guns with compact design and low combustion energy are by now available on the market, only little is known about the effects and interactions of the spray parameters on the particle behavior and the coating properties. Due to the mentioned gun specifications and the usually required short spray distances for ID coating, fine spray powders < 15 μm must be used to ensure sufficient melting and acceleration of the particles. In this study warm spraying of fine WC-12Co powders (-10 + 2 μm) using a novel spray gun “ID RED” (Thermico, Germany) was investigated. Statistical design of experiments (DoE) was employed to analyze and to model the influence of varying spray parameter settings on the in-flight particle behavior and the corresponding coating properties.