Abstract
The impact experiment of the joining workpiece of the friction stir jointing for 7022 aluminum alloy was made by the impact load experiment machine. The objective was studying the effect of the different joining process parameters of the FSJ on impact toughness. The results showed the impact toughness of the joining region was lower than that of the base metal when the rotation speed of the tool was 300rpm and the feed speed was 30 and 50mm•min-1, the impact toughness of the joining region of the other joining process parameters was higher than that of the base metal. The impact toughness of the joining region was the best when the rotation speed of the tool was 400rpm and the feed speed was 100mm•min-1. It is higher than 22.3% of the base metal. The impact fracture of the joining region was mainly dimple; only fracture edge appeared a small amount of the quasi cleavage. The fracture presented good toughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
