Abstract
The properties of a denture base material may be modified by altering both the temperature and the time of heating during the curing cycle. In this study a polymethylmethacrylate denture base containing no crosslinking agent was polymerised using four different curing cycles. The structure of the materials so obtained was investigated by an acid etching technique. The materials were characterized with respect to degree of cure, strength and water sorption. It was concluded that: 1. No correlation was observed between the curing cycles and polymer structure. 2. The curing cycle of 7 h at 70 degrees C plus 1 h at 100 degrees C produced best indentation strength and tensile strength. 3. A correlation was observed between residual monomer, indentation resistance, tensile strength and water sorption. This suggested that residual monomer concentration is the most important parameter in the determination of the properties of the material investigated in this study.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
