Effect of the Cryogenically Treated Copper Nozzle Used in Plasma Arc Machining of S235 Steel

Abstract

The investigation was carried out by making use of the design of experiments method in order to achieve its objective, which was to study wear analysis in relation to a cryogenically treated nozzle that was utilized in plasma arc machining. Kerf width and surface roughness are two output characteristics that are key variables in deciding the quality of the cut and the efficiency of the operation. Both of these metrics are outputted by the process. While machining S235 steel, an investigation into the impact that nozzle treatment has on various quality metrics is currently under way. The examination is carried out with the arc voltage, the cutting speed, and the gas pressure, all serving as important components. A cryogenic treatment of the nozzle material using liquid nitrogen at a temperature of −194°C has been attempted in an effort to increase the life of the nozzle. Machining is performed using two different nozzle conditions, such as cryogenically treated and cryogenically untreated, with regard to the input parameter combinations that have been selected. To have a better understanding of the wear behavior of nozzles, an image from a scanning electron microscope is studied. Because of the treatment, the production of wear tracks in the direction that gas flow takes has been drastically decreased. This, in turn, has increased the cutting efficiency by decreasing the amount of arc current that was necessary. In addition, a grey relational analysis is carried out in order to find the best possible machining settings in both conditions. The parameters that were optimized for a nozzle that had been cryogenically treated were 6 bar of gas pressure, 120 amperes of arc current, and 1800 of cutting speed per minute. The use of cryogenic treatment resulted in a reduction of surface roughness by 0.4670 µm and a narrowing of the kerf width by 0.96 mm. It is clear from the SEM pictures of untreated and cryogenically treated nozzles that thermal distortion and wear in the nozzle tip area are minimized to a greater extent in the treated nozzle. This is evidenced by the fact that the treated nozzle has a more uniform appearance.