Effect of the composition ratio of pimelic acid/calcium stearate bicomponent nucleator and crystallization temperature on the production of β crystal form in isotactic polypropylene

Abstract

AbstractThe influence of the composition ratio of pimelic acid/calcium stearate bicomponent nucleator on the β crystal form content of isotactic polypropylene (iPP) had been studied at the crystallization temperature of 120°C and duration of 30 min. It was found that the β crystal form content increased continuously with increasing amount of calcium stearate at the constant amount of 0.15% pimelic acid. High β crystal form content polypropylene could be produced when the amount of calcium stearate was greater than 0.30% (the mass composition ratio of pimelic acid/calcium stearate was less than 1/2, the mole ratio was less than 1.89/1). It was shown that pimelic acid and calcium stearate could react to produce a high effective β nucleator (calcium pimelate) “in situ” during the melt‐mixing of iPP and the bicomponent nucleator. The influence of crystallization temperatures (100–140°C) on the β crystal form content of iPP had also been studied at the constant composition ratio of 0.15% pimelic acid/0.5% calcium stearate (the calcium pimelate produced in situ was 0.16%, which was calculated from stoichiometry). It was found that the β crystal form content increased continuously with increasing crystallization temperature and it maximized at 130°C. β Crystal form content decreased sharply at the crystallization temperature of 140°C. It was shown that β → α modification transformed between 130 and 140°C. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008