Abstract
Fruit leathers are pectic gels, eaten as snack or dessert, obtained by dehydrating fruit purees. In this work, apple leathers were prepared by a hot-air drying process which allows the formation of a gel, following the “saccharide–acid–high methoxyl pectin” gelation mechanism. Leathers were produced at 50, 60 and 70°C, from two formulations: control and added with potassium metabisulphite (KM) as antioxidant. The drying process was studied applying a diffusive model, while antioxidant capacity (AC) losses were represented by a first-order model. Activation energy for drying (20.6kJ/mol) was lower than those estimated for AC losses in control (31.5kJ/mol) and KM-added (37.9kJ/mol) leathers. Therefore, the drying time reduction achieved by increasing air temperature is not sufficient to decrease AC losses in the range covered. AC retention decreased in both formulations at increasing air temperature. KM-added samples showed higher AC retention than the controls, except for those dried at 70°C. Kinetic constants were lower for KM-added samples, suggesting a protective effect of the additive, especially at moderate air temperatures. In the most favorable situation, AC retention was of only 16%. Therefore, the functional character of these products may not be preserved if dried with hot air and the research on economically viable, less-severe drying technologies should be intensified.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.