Effect of temperature on flexural and interlaminar shear strength properties of carbon‐epoxy composites: Experiment and modeling

Abstract

AbstractCarbon fiber composites are known for excellent specific mechanical properties at room temperature. It is important to model the effect of temperature on flexural strength and interlaminar shear strength (ILSS). In this study, T700 carbon fiber composites with two different epoxy resins (Epofine, LY556) were prepared using filament winding and named as TE and TL composites. The dynamic mechanical analysis (DMA) tests revealed Tg of 177 and 192°C for TE and TL composites, respectively. Three‐point bending (flexural) and short‐beam shear (ILSS) tests were performed at −20, 0, RT, 90, 105, 150, 170, and 200°C. It was observed that flexural strength and ILSS decreases linearly with increase in temperature. Fracture analysis of flexural samples revealed fiber breakage at −20°C and micro‐buckling at elevated temperature are dominant failure mechanisms. Fracture analysis of ILSS samples showed delamination with microcracking at −20°C and plastic deformation of matrix at elevated temperature. A new empirical model was proposed to predict the temperature dependent flexural strength and ILSS. With this model, variation of flexure strength and ILSS with temperature can be estimated from respective values at RT, Tg and storage modulus values from DMA, thus extensive experimentation at high temperatures can be avoided.Highlights Mechanical properties of filament wound composites are tested from −20 to 200°C. Flexural strength and ILSS linearly decreases with increase in temperature. Fiber breakage at −20°C and micro bucking at 200°C are dominant in flexure. Delamination at −20°C and plastic deformation at 200°C are dominant in ILSS. Analytical model for finding temperature dependent flexural strength and ILSS.