Effect of temperature and pH on droplet aggregation and phase separation characteristics of flocs formed in oil–water emulsions after coagulation

Abstract

Coagulation process is used for destabilization of emulsions to promote aggregation of oil droplets on flocs which can be subsequently removed by sedimentation or flotation. The objectives of this study were to investigate the effect of temperature and pH on the effectiveness of destabilization of olive oil–water emulsions in relation to floc morphology and aggregation characteristics of oil droplets, and to quantify the ability of flocs to capture and separate oil. A cationic polyelectrolyte was used for the coagulation of oil droplets in edible olive oil–water emulsions using a jar test apparatus. The flocs formed in olive oil–water emulsions after coagulant addition were analyzed using microscopic image analysis techniques. Fractal dimension, radius of captured oil droplets on flocs, number of oil droplets aggregated on flocs, and floc size were used to quantitatively characterize and compared the effectiveness of the coagulation process at different conditions (pH and temperature) and the ability of flocs to remove oil from water. Analysis of microscopic images showed that floc size was not always the best measure of effectiveness of coagulation process in oil–water emulsions. The flocs forming at different pH levels and temperatures had significant morphological differences in their ability to aggregate different sizes and numbers of oil droplets, resulting in significant differences in their ability for separating oil. Fractal dimension did not correlate with the ability of flocs to aggregate oil droplets nor the total amount of oil captured on flocs. Temperature had a significant effect on droplet size and number of droplets captured on flocs. The differences in floc sizes at different temperatures were not significant. However, the flocs forming at 20 °C had fewer but larger droplets aggregating larger amounts of oil than flocs formed at 30 °C and 40 °C. The size of droplets at different pH levels was similar, however, there were significant differences in number of droplets aggregating on flocs and floc sizes. The amount of oil captured on flocs at pH 7 and pH 9 was significantly higher than those at pH 5 and pH 11. The calculated fractal dimensions of the flocs (all less than 1.8) indicated that the coagulation process was diffusion limited implying that there was no repulsion between the colliding particles (i.e., droplets and flocs); hence, each collision between flocs and droplets resulted in attachment.