Effect of surface radiation on the stability of hypersonic flat plate boundary layer

Abstract

Transition of hypersonic boundary layer flow is an important problem in aerodynamic research. To obtain the natural transition position using the flow stability analysis method, it is necessary to analysis the neutral curve and the perturbation growth rule. Accurate calculation of the basic flow is the basis and prerequisite for stability analysis. This paper proposes that surface radiation should be considered in the analysis of hypersonic boundary layer flow stability due to the high temperatures at the vehicle surface caused by aerodynamic heating. In order to obtain the influence of surface radiation on the flow stability, we assume that the surface satisfies the energy balance and the gas satisfies calorimetrically perfect gas properties. To simplify the analysis, gas radiation has been neglected. The boundary layer analysis of a hypersonic flat plate with and without radiation has been performed by a combination of flow stability theory and direct numerical simulation. It is found that high temperature radiation on the surface causes energy to transfer outwards. The results showed that surface temperature decreases along the streamwise direction and is no longer an adiabatic surface temperature. Instability interval decreases and the maximum growth rate increases. The range of the instability region expressed in dimensionless frequency values moves to lower frequency as the Mach number increases. Maximum growth rate shows a tendency to increase and then decrease as the Mach number increases.