Abstract
The focus of this paper is to describe the effect of change in surface friction of single layer para-aramid (Twaron®) square woven fabric and change in knife penetration angle on its Quasi-Static Knife Penetration Resistance (QSKPR). The surface friction of fabric was changed by depositing SiO2 on its surface by using water glass as a precursor. Six different knife penetration angles (0°, 22.5°, 45°, 67.5°, 90° and 135°) were selected. Untreated and treated fabric samples were compared for change in QSKPR. It was observed that the deposition of SiO2 on the surface of Twaron® fabric increased the surface friction which resulted in the increase in QSKPR. The response of fabric against QSKPR changed from partial yarn cutting to individual yarn cutting in fewer steps and load was distributed to a larger area due to decrease in yarn slippage. The change in penetration angle changed the distance, knife cutting edge travelled to cut each next yarn(s) and when this distance increased, the QSKPR was reduced. The post-penetration image analysis of damaged fibres showed that the load distribution among warp and weft yarns was complementary and change in penetration angles changed the distribution of stabbing load among the warp and weft yarns. When yarns with higher tensile strength and less slippage were loaded, the fabric showed highest resistance to penetration. A QSKPR prediction model was also proposed at the end.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have