Abstract
This paper presents the results of experimental work carried out to study the influence of surface integrity, measured as hardness (HV) and roughness (Ra) on torsional properties of annealed AISI 1020 steel machined by turning using carbide insert tools. The results showed a reduction in ductility when hardness and roughness increase, caused by the plastic deformation induced after machining. It was shown that the shear yield strength increases, as a consequence of the material strengthening by work-hardening and the rise of stress concentrators. Further, the ultimate shear strength increases with surface hardness, having the opposite effect when the surface roughness caused greater stress concentration.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Revista Facultad de Ingeniería Universidad de Antioquia
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
