Effect of Surcharge on the Stability of Anchored Rock Slope with Water Filled Tension Crack under Seismic Loading Condition

Abstract

In this paper, an analytical expression is derived for the factor of safety of the rock slope incorporating most of the practically occurring destabilizing forces as well as the external stabilizing force through an anchoring system. The slope stability is analyzed as a two-dimensional problem, considering a slice of unit thickness through the slope and assuming negligible resistance to sliding at the lateral boundaries of the sliding block. A detailed parametric study is presented to investigate the effect of surcharge on the stability of the rock slope for practical ranges of governing parameters such as inclination of the slope face, inclination of the failure plane, depth of tension crack, depth of water in tension crack, shear strength parameters of the material at the failure plane, unit weight of rock, stabilizing force and its inclination, and seismic load. For the range of parameters considered in the present study, it is found that the factor of safety of the rock slope decreases with increase in surcharge; the rate of decrease being relatively higher for lower values of surcharge. It is also observed that for a specific surcharge, the factor of safety depends significantly on all other parameters, except for unit weight of rock and higher values of inclination of stabilizing force to the normal at the failure plane. For any combination of these variables, the surcharge plays a vital role in the stability. A perfectly stable slope at relatively low surcharge can become unsafe with the increase in surcharge. The deterioration in the stability can be quite rapid, depending on the combination of the factors under consideration. The analysis and the general expression proposed herein can be used to carry out a quantitative assessment of the stability of the rock slopes.