Effect of stress ratio on long life fatigue behavior of Ti-Al alloy under flexural loading

Abstract

A new ultrasonic three-point bending fatigue test device was introduced to investigate fatigue life ranging up to 10 10 cycles and associated fracture behavior of Ti-Al alloy. Tests were performed at a frequency of 20 kHz with stress ratio R=0.5 and R=0.7 at ambient temperature in air. Three groups of specimens with different surface roughness were applied to investigate the effect of surface roughness on fatigue life. Furthermore, optical microscopy(OM) and scanning electron microscopy(SEM) were used for microstructure characteristic and fracture surface analysis. The S— N curves obtained show that fatigue failure occurs in the range of 10 5 -10 10 cycles, and the asymptote of S— N curve inclines slightly in very high cycle regime, but is not horizontal for R=0.5. Fatigue limit appears after 10 8 cycles for R=0.7. Surface roughness (the maximum roughness is no more than 3 μm) has no influence on the fatigue properties in the high cycle regime. A detailed investigation on fatigue fracture surface shows that the Ti-Al alloy studied here is a binary alloy in the microstructure composed of α 2-Ti 3Al and γ-Ti-Al with fully lamellar microstructure. Fractography shows that fatigue failures are mostly initiated on the surface of specimens, also, in very high cycle regime, subsurface fatigue crack initiation can be found. Interlamellar fatigue crack initiation is predominant in the Ti-Al alloy with fully lamellar structure. Fatigue crack growth is mainly in transgranular mode.