Abstract
SUMMARYThe quality of phosphate coatings deposited on steel surfaces vary quite widely depending on the surface condition of the substrates. A systematic study of a set of commercial steel samples with essentially similar bulk composition, reveals that wide variation in coatings morphology may be attributed to the differences in steel surface composition viz the amount of surface carbon and iron oxides. The ratio of surface iron and carbon seems to be a reliable index in grading steel sheets with respect to phosphatability. XPS study indicates that the surface Fe/C ratio decreases systematically from a value of 0.41 to 0.15 for the steel samples with best quality phosphates coating to those with poor quality phosphate coating. The morphology of phosphate coatings was determined by scanning electron microscopy (SEM) and the bulk composition of steel samples was determined by vacuum emission spectroscopy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.