Abstract
This study aims to elucidate the effect of stacking fault energy (SFE) on the microstructural evolution and related hardening mechanisms of Fe−18Mn−0.6C−(0 and 1.5)Al and Fe−30Mn−3Al−3Si (wt.%) twinning−induced plasticity (TWIP) steels during friction stir welding (FSW) using a high−resolution electron backscattered diffractometer. With increasing SFE, the intensities of the Goss, CuT, and Brass components increased via active dynamic recrystallization (DRX) accompanied by twinning. The 30Mn weld, which had the highest SFE, exhibited the highest recrystallization fraction (94.8 %) and an increasing rate of hardness (40.9 %). This is because a higher SFE can enhance dislocation mobility, leading to an active rate of continuous DRX as well as discontinuous DRX. Consequently, the refinement of the recrystallized grains effectively assisted the hardening of the 30Mn weld after FSW. Hence, we concluded that SFE should be considered to improve the properties of TWIP steels after FSW.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
