Effect of solvent and thermal annealing on D18/Y6 polymer solar cells

Abstract

Organic solar cells (OSCs) as emerging generation solar cells are required to face climate and energy challenges. In this regard, OSCs based on the D18:Y6 active layer with a ratio of 1:1.6 with thermal and solvent annealing as a post-treatment were fabricated. The effect of different thermal annealing with chloroform on the active layer and the cell performance was studied. Optical, morphological and thermal analysis are executed to investigate the effect of thermal with solvent annealing on the D18:Y6 active layer. Photoluminescence (PL), transmission electron microscope (TEM) and atomic force microscope (AFM) reveal that D18:Y6 film treated at 55 °C with chloroform for 5.0 min had the lowest PL intensity, interpenetrating grain networking structures and more smoother surface leads to optimize photo-induced charge transfer and exciton dissociation in the active layer. D18: Y6 blend film annealed at 80 °C with chloroform for 5.0 min exhibits higher roughness of 17.81 nm than 11.60 nm for D18:Y6 blend film treated at 55 °C. As a result, the optimal performance of the fabricated conventional OSCs based on active layer treated at 55 °C with chloroform had short-current density (Jsc), open circuit voltage (Voc), fill factor (FF) and efficiency of 60 mA/cm2, 0.70V, 39.8% and 16.5%, respectively. This study indicates additional thermal annealing with chloroform as a post-treatment enhances the device performance of OSCs.Graphical abstractStudying the effect of solvent vapor annealing with thermal annealing of D18:Y6 layer aspost-treatment on the performance of organic solar cells.