Abstract
A mathematical model was developed to investigate the effect of snorkel shape on the recirculation rate and the erosion of the lining refractory during RH degassing process. A particle image velocimetry technique was used to measure the velocity distribution in a water modelling experiment. The calculated results were well validated with the measured ones. In the mathematical model, the interfaces between the molten steel and the gas phase, and the motion of argon bubbles were simulated and tracked using VOF + DPM model by which the argon bubbles were treated as the discrete phase in the molten steel and the top gas phase, and the top gas phase was treated as a second continuous phase. It was found that the recirculation rate of the molten steel with oval snorkels was significantly larger than that with round snorkels. For round snorkels, the optimum gas flow rate was 1800 L min−1 and it was 2800 L min−1 for oval snorkels. Furthermore, the volume distribution of the argon in the radial direction of the up-snorkel with oval snorkels was much more homogeneous than that with round snorkels. Meanwhile, the predicted maximum wall shear stress showed that the bottom and the sidewall of the ladle with round snorkels were more seriously eroded than that with oval snorkels. Therefore, the oval snorkel was beneficial to improve the service life of the RH degasser.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.