Effect of slurry rheology on gas dispersion in a pilot-scale mechanical flotation cell

Abstract

This paper investigates the effect of slurry rheology on gas dispersion in a 100 l pilot-scale Batequip mechanical flotation cell. The study is conducted using Kaolin, Bindura nickel and Platreef slurries. All three ores display typical non-Newtonian rheological behaviour. The slurry yield stress and viscosity increase exponentially with solids concentration. Bubble size and gas hold-up vary from 0.60 to 1.10 mm and 2% to 15%, respectively. At low/moderate solids concentrations, bubble size and gas holdup display characteristic trends, as noted in numerous literature studies. At high solids concentrations, both bubble size and gas holdup decrease significantly, which is an unexpected finding. This is attributed to the formation of a ‘cavern’ of slurry around the impeller, due to the very high slurry yield stresses. This ‘cavern’ results in the generation of small bubbles in the impeller zone, but poor dispersion of these bubbles throughout the cell, resulting in low gas hold-ups.