Effect of slag recycling on bead geometry, dilution and microstructure in submerged arc cladding of stainless steels

Abstract

The submerged arc welding (SAW) process generates a large quantity of slag, which, when disposed-of, harms the environment and wastes valuable ingredients. A technology was developed to recycle the SAW slag generated in stainless steel cladding, enabling its reuse as flux. Bead geometry and dilution play crucial roles in weld cladding. Dilution determines the minimum number of layers needed to achieve the desired chemistry, while bead width dictates the fewest passes required to cover the entire surface area. Additionally, bead geometry influences the mechanical strength of the clad layers. The microstructure and solidification mode also significantly affect clad quality. Therefore, understanding the impact of recycled slag on bead geometry, dilution, and microstructure is essential. This paper presents a systematic investigation into the effects of process variables and recycled slag on bead geometry and dilution in clad welding. It includes a comparison of microstructures obtained using fresh flux versus recycled slag. The results indicate that increasing the welding current (I) by 37.5% enhances weld penetration (p), bead width (w), reinforcement (r), and dilution (d) by 50.9%, 14.4%, 69.5%, and 5.5%, respectively. Conversely, increasing the travel speed (V) by 90%, decreases p, w, and r by 19.29%, 11.9%, and 25.3%, respectively; however, dilution (d) increases by 17.6%. On the other hand, increasing the open-circuit voltage (V) by 26.7% increases bead width (w) and dilution (d) by 10.4% and 5.4%, respectively, while reinforcement (r) decreases by 7.5%. Both single and multilayer claddings prepared with fresh flux and recycled slag exhibit similar microstructures.