Effect of single and dual doping on the thermoelectric properties of FeVSb0.95Sn0.05 and Fe0.95Co0.05VSb0.90Sn0.10 half-Heusler alloys

Abstract

FeVSb in addition to a set of novel FeVSb0.95Sn0.05 and Fe0.95Co0.05VSb0.90Sn0.10 half-Heusler alloys were fabricated by arc melting followed by induction melting simple methods. Impacts of single Sn-doping and double Co- and Sn-doping on the structural and thermoelectric properties of FeVSb were investigated in this article. Structural and thermoelectric properties of FeVSb, FeVSb0.95Sn0.05 and Fe0.95Co0.05VSb0.90Sn0.10 compounds have been extensively studied in this work. N-type conduction was confirmed for the FeVSb system and for the doped FeVSb0.95Sn0.05 and Fe0.95Co0.05VSb0.90Sn0.10 alloys. The absolute value of Seebeck coefficient for the single Sn-doped sample increased from 127 μV/K to 155 μV/K, with the temperature increasing. Similarly, the Seebeck coefficient of the double Co- and Sn-doped alloy also increased from 40 μV/K to 60 μV/K. The thermoelectric power factor was notably enhanced for the dual doped Fe0.95Co0.05VSb0.90Sn0.10 alloy reaching 14 μW/cm.K2. Lattice thermal conductivity of the single Sn-doped FeVSb0.95Sn0.05 alloy decreased considerably over the whole temperature range. A maximum zT of 0.084 was achieved for FeVSb0.95Sn0.05 alloy at 575 K. The improved figure of merit due to doping is attributed to the phonon scattering at point defects. Sn-doping has significantly reduced thermal conductivity due to the enhanced point-defect and electron–phonon scatterings which contributed to improved thermoelectric figure of merit. Our findings showed also that the room-temperature thermal conductivity is seriously reduced via Sn and Co dual doping leading to higher ZT value for Fe0.95Co0.05VSb0.90Sn0.10 alloy. Promising candidates for further thermoelectric applications could be achieved by Sn-doping and double Co- and Sn-doping.