Abstract
In this study, the surface of St52 steel was alloyed with preplaced powders 55Fe39Cr6C, 49Fe39Cr6C6Si, and 45Fe39Cr6C10Si using a tungsten-inert gas as the heat source. Following surface alloying, conventional characterization techniques, such as optical microscopy, scanning electron microscopy, and X-ray diffraction were employed to study the microstructure of the alloyed surface. Microhardness measurements were performed across the alloyed zone. Room-temperature dry sliding wear tests were used to compare the coatings in terms of their tribological behavior. It was found that the as-deposited coatings contained higher volume fractions of carbides (Cr7C3). The presence of 6%Si in the preplaced powders caused an increase in microhardness and wear resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
