Abstract
The objective of this study was to investigate the effect of side holes on the predicted von Mises stress levels in cervical spinal fusion cages subjected to compressive loading. Models with between zero and ten side holes were developed. Finite element analysis (FEA) was used to simulate compression of the cage, made from the polymer PEEK (polyetheretherketone), between two adjacent vertebrae. The analyses were validated by experimental tests. In all of the models, the von Mises stress was highest at the cage-vertebrae interface with peak stresses of between 14 and 18 MPa. Increasing the Young's modulus of the vertebrae from 12 to 30 GPa increased the peak stress on average by 29 per cent. The stresses in the models were lower than the compressive strength of PEEK (118 MPa), and are well within the PEEK fatigue strength reported (60 MPa at 10 million cycles). This study suggests that the number of side holes had a negligible effect on the stress distribution within the cage; the stress magnitudes were fairly constant across all of the models and did not change substantially with the number of holes. Hence, a cervical cage with side holes is unlikely to fail in compression.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
