Effect of shape and size of supraspinatus tears on rotator cuff strain distribution: an invitro study.

Abstract

The impact of the size and shape of a supraspinatus tear on the strain of the intact rotator cuff and the kinematics of the shoulder is still unknown. This, however, can be relevant when deciding whether surgical reconstruction is required to prevent an increase in a tendon defect. In this study, the effect of tear width and shape on rotator cuff strain and glenohumeral kinematics was evaluated during active abduction. Twelve fresh-frozen cadaveric shoulders with intact rotator cuffs were used in this study. We created 50% and 100% wide (full-thickness) crescent-shaped (CS) tears (n=6) and reverse L-shaped (rLS) tears (n=6) in the supraspinatus tendon and measured strain and kinematics during active humeral elevation until 30°. Both tear shapes and sizes led to an increase in internal rotation, supraspinatus loading force, and superior translation of the humerus. For the 100% wide tear size, anterior translation was observed in the CS tear group, whereas in the rLS tear group, this translation occurred mainly in the posterior direction. Strain was higher in the infraspinatus during the first 25° of abduction in comparison with the supraspinatus tendon in both tear shape groups. An analysis of the anterior and posterior tear borders showed a higher strain concentration on the same side of the tear in the CS tear group with 50% and 100% wide tears. The influence of different tear shapes on translation in the anterior-posterior direction was evident as both CS and rLS tears led to an oppositely directed translation of the humeral head. The strain analysis showed a stress-shielding effect of the infraspinatus at the beginning of abduction. Therefore, special attention must be paid to correctly identify the tear extension and adequately reconstruct the rotator cuff footprint. Moreover, the constant location of maximum strain in the CS tear group may lead to an earlier progression than in the rLS tear group.